SuperDeep Ultra Clear Casting Resin

SuperDeep Ultra Clear Casting Resin

SuperDeep Casting Resin is a 2 part (2 parts A and 1 part B) Very Slow Curing Epoxy resin which when mixed with hardener is poured into a mould and sets to a strong, hard finished product. Resistant to most household chemicals and can withstand surface temperatures around 80-85C (resisting marks from hot drinks etc).  The special SuperDeep casting character allows this product to do deep casting up to 55mm in large quantities without generating exothermic heat.

This resin is to be used on 25mm+ depths. For shallower casting please use Fast Cure

Mixing Instructions

1. Mix resin and hardener in exactly 2:1 ratio by volume ( 2 parts A and 1 part B) Use a plastic or silicone container for mixing and mix thoroughly
2. Scrape sides and bottom of the container to fully integrate products.
3. Use a mixing container that is clean and free of contamination. Tiny contamination would deteriorate the quality of the final result. Do not use metal, especially aluminium containers to mix or mixtures will turn milky colour.
4. Once the product is poured into the mould, let the resin settle allowing air bubbles or foam to float to the surface, most bubbles will float to the surface and burst themselves.
5. Any remaining bubbles or foam can be removed with a heat gun or Blow torch, sweep the heat gun continuously across the surface for a few seconds and avoid overheating in one spot.
6. Curing can take 3 plus days depending on depth.

100% Australian-owned and Australian manufactured

Larger quantities are available upon request, please contact us. 

Features

• Binds to metal, inorganic materials including cement; and stone, natural materials including wood; particle board, most plastics except polyethylene, polypropylene, EPDM. 
  
• No VOC; Zero Solvent; BPA Free; Eco Friendly; Meet and Exceed Australian Standard AS 2311-2017 and ASTM D3960-05
• Crystal Clear Finish: Cures Crystal Clear. One of the clearest epoxies you can find. Suitable for wooden bar tops, embedding pictures, bottle cap table projects & more 
• UV Resistant Formula: Added UV Inhibitors resist yellowing when exposed to the sun and Ultra Violet light 
• Self-Level Mixture: Will self level over surfaces including corners, bar rails and edges leaving a consistent thickness    
• Superior Air Release: Some epoxies may bubble, fish eye or crater. Our formula features superior air release, minimizing these concerns   
• Impact Resistant: Cures super strong, leaving a smooth impact-resistant surface   
• Minimal odour and yellowing after long period of time.

 

Important Notes

• Mixing quantity (the more you mix, the fast it cures and vice versa)
• Room Temperature (higher room temperature will speed up the curing) 
• Mixing ratio: 2:1 (2 Parts A and 1 Part B)
• Application temperature: Wide temperature range through summer to winter 
• Pot life: 3-4 hours (Data based on 500ml mixing; 40mm pour depth; 20 degree C room temperature). Please pour this product into mould as soon as possible, to avoid bubbling.
• Time to reach non-tacky: 15-25 hrs Depending on the room temperature (Data based on 500ml mixing; 40mm pour depth)
• Time to reach full cure: 72 hrs (Data based on 500ml mixing; 40mm pour depth)
• Viscosity: 600 cps for Part A (Brookfield 20 rpm)
• 250 cps for Part B (Brookfield 20 rpm)
• Clarity: Pt-Co value < 10 for both Part A and Part B

Available order quantity: 750 Mls, 3 Ltr, 6 Ltr 30 Ltr 300 Ltr

Shelf life: 12 months 

Manufactured in Australia by Eparency 

For MSDS Please contact us or Eparency directly.